Cement rotary kiln is a piece of cement equipment with strong durability, also plays a vital role in the cement plant. If you find any problem in the operation, solve it immediately. In general, the maintenance of rotary kiln is a complex process, here are some tips will be helpful.

Refractory material

First of all, check the fire hole of the rotary kiln is closed or not, ensure the close state to avoid too much cold air. Then, check the windshield of the burner at the kiln door is close to the kiln door. If the air leakage is not closed, it should be pushed to the position of close contact with the kiln door. Third, check the door cover of rotary kiln, if there is the phenomenon of positive pressure ash, should inform the central control to adjust properly. Finally, remember to check air leakage or wear out the phenomenon of resistant material, when you find the above problems, promptly inform the relevant leadership to deal with them.

Sealing and wearing parts

Check the fish scales sealed in the kiln head, and then check the fitting condition of the fish scales in the rotary kiln and friction ring. If there is any bad condition such as non-fitting, the weight should be adjusted by tightening the device to make it fit. If there is too much aggregate in the reliable rotary kiln, the discharging pipe should be adjusted timely. After that, check the wear condition of the friction ring of rotary kiln. If the friction ring is found to be badly worn or worn out, replace it.

Internal parts

Check the cooling air at the kiln head, and then check the friction between kiln head and the kiln door cover. In order to ensure safety, check the oil film contact of the supporting wheel shaft and thrust plate one by one. Check oil level, oil scoop and oil distribution of rotary kiln. Next, check whether there are impurities, water droplets, oil leakage, collision, loosening and other abnormal conditions, if necessary, the temperature can be measured and control.