Temperature monitoring at a number of kiln locations is essential to ensure product quality, optimize throughput, minimize emissions, and to prevent damage to the kiln shell and material handling conveyors. Critical monitoring areas are process material preheat, mid-kiln, burning zone, kiln shell and clinker cooler.

Process Material Pre-Heat

To improve efficiency and reduce emissions, exhaust gases from the kiln are used to preheat the rawmix feed material before it enters the kiln. Inadequate preheating can signal problems in the heat exchanger that will increase fuel consumption costs. Process Sensors Corporation (PSC) 1-color pyrometers can be installed to sight on free-falling preheat material or preheater feed tower wall to alert when temperature falls below a preset level. 2-color sensor models are effective for measuring feed material that is hotter than the vertical tower walls as they can disregard colder temperatures often present in their sight path.

Mid-Kilnthermal image of kiln shell temperature

Most modern kilns have a 4 to 5 inch inside diameter by 4 to 5 foot long target tube in the sidewall of the kiln where monitoring mid-kiln temperature is critical to ensure kiln integrity. A PSC Non-Contact Infrared (IR) Pyrometer is recommended for measurement reading during each rotation of the kiln. A variety of fixed focus optics are available where users may choose to integrate laser-aiming light to determine exact alignment to the bottom of the target tube.

Burning Zone

The burning zone is the last stage before the material exits the kiln. A single burner fires toward the approaching material, and precise temperature measurement is important to control the firing of the burner. A PSC 2-color pyrometer is effective for monitoring the burner zone as they compensate for dust that can obscure the sight path. Alternatively, a PSC Thermal Imaging Camera is recommended to understand the thermal profile inside of the kiln. Non-Contact Infrared (IR) Pyrometers should not be sighted through the flame, but along the axis or below the flame.

Kiln Shellcement and lime kiln temperature

Uneven heating of the kiln shell distorts the metal skin and the cylinder can become banana shaped, damaging the bearings, causing a process shutdown. A PSC thermal imaging camera detects uneven kiln shell heating with real time thermal images so damage and unwanted shutdowns can be avoided. The thermal imaging camera can also be switched into line-scan mode, enabling the customer to easily and quickly replace an old line scanner camera.

Clinker Cooler

Hot process material exiting the kiln (clinker)  is conveyed under cooling water sprays. Failure to cool the clinker thoroughly can result in fires at inaccessible locations along the conveyor, or in ball mills. Installation of PSC pyrometers and/or thermal imaging cameras can detect an inadequately cooled clinker to protect against fire.